FusionServer 2288 V5 Server
Technical White Paper
5 Hardware Description
2022-11-11
23
Port
Type
Quantity
Description
For details, see 5.6.1 LOMs .
VGA port
DB15
1
Used to connect a display terminal, such as
a monitor or KVM.
Serial port
RJ45
1
Default operating system serial port used for
debugging. You can also set it as the iBMC
serial port by using the iBMC command.
NOTE
The port uses 3-wire serial communication
interface, and the default baud rate is 115,200
bit/s.
Management
network port
1000BASE-
T
1
Used for server management.
NOTE
The management network port is a GE port that
supports 100 Mbit/s and 1000 Mbit/s
auto-negotiation.
USB port
USB 3.0
2
Used to connect to a USB device.
NOTICE
Before connecting an external USB device,
check that the USB device functions properly.
The server may operate abnormally if an
abnormal USB device is connected.
PSU socket
-
2
Used to connect to the power distribution
unit (PDU) in the cabinet. You can select
the number of power supply units (PSUs) as
required.
NOTE
⚫
When determining the quantity of PSUs,
ensure that the rated power of the PSUs is
greater than that of the server.
⚫
If only one PSU is used,
Predicted PSU
Status
cannot be set to
Active/Standby
on
the iBMC WebUI.
5.3 Processor
⚫
The server supports one or two processors.
⚫
If only one processor is required, install it in socket
CPU1
.
⚫
The same model of processors must be used in a server.
⚫
Contact your local sales representative or use the
components to be used.