K021 Instructions v1.0
Bag I
Page 68
I14)
Apply the window masks to the inside of the body, still attached to their low-tack
backing tape. Line up the white masks with the window lines molded in the body.
Once lined up, firmly press the masks to the lexan: they’ll seem to turn from white
to blue once fully pressed on. In the left photo below the lower part of the mask
is fully pressed on (large arrow) and the top part of the mask has not been
pressed firmly (small arrow). Finally peel off the backing tape, leaving the
window masks on the inside of the body.
I15)
After painting your dialed scheme, carefully peel off the outside surrounding edge
of the window masks. This will give a nice even border around the windows to
spray a quick color. Spray a backing color if you want, and once everything’s
finally dry peel off the main portion of each window. Remove the blue over-spray
film from the outside of the body, and carefully trim the body along its cut lines.
There are two lines along the bottom edges of the body; if you are running a
larger LiPo battery you’ll probably want to use the lower line, which raises the
body up some and helps clear the battery posts. Use the supplied Velcro from
Bag I on each side of the body and chassis to hold the body on the car.
