18
Set SNMPv3
1.
Click [+] on the left of the [Connectivity] folder on the [Properties] screen.
2.
Click [+] on the left of the [Protocols] folder.
3.
Click [SNMP Configuration].
4.
Check the [Enable SNMPv3 Protocol] box.
5.
Uncheck the [Enable SNMP v1/v2c Protocols] box.
6.
Click the [Apply] button.
7.
Click the [Edit SNMPv3 Properties] button and check the [Account Enabled] for [Administrator Account].
8.
Enter a new Authentication Password (minimum 8 characters).
9.
Enter the Confirm Authentication Password.
10.
Enter a new Privacy Password (minimum 8 characters).
11.
Enter the Confirm Privacy Password.
12.
Check the [Account Enabled] for [Print Drivers/Remote Clients Account].
13.
Click the [Apply] button.
Note:
•
Authentication Password and Privacy Password have to be changed certainly from default Password.
•
In using SNMPv3, use the IPSec protocol simultaneously. Therefore the IP address of the client for SNMPv3
have to be set according to the procedures "Set IPSec Address" (3.5).
Enter the IP Address in the [Specify Destination IPv4 Address] box.
•
Since the machine cannot communicate by SNMP v1/v2, the port setting on the client Print Driver have to be
select [LPR] for [Protocol], and uncheck the [SNMP status Enabled].
