a.
At the control panel, press the
Tools
button.
b.
From the screen that displays, select the
Tools
icon.
c.
Select
System Settings
→
Common Service Settings
→
Maintenance
.
d.
Use the arrow buttons to access the next
Maintenance
screens.
e.
Select the
Technical Key Operator
icon.
The
Technical Key Operator
feature displays.
f.
Log in to the
Technical Key Operator
mode.
Attention
If you cannot log in as TKO or do not have the TKO password, call your Customer Service
Engineer.
g.
Select the item that corresponds with the newly-replaced components.
h.
Select
Reset Current Value
. The system resets the High Frequency Service Item (HFSI) to 0.
i.
Repeat the previous steps until the counters for all three components are reset to zero (0).
j.
Exit administrator mode by pressing the
Log In or Out
button on the control panel.
When prompted, select
Logout
.
RReeppllaacciinngg aa D
Drryy IInnkk//TToonneerr C
Caarrttrriiddggee
Note:
The dry ink/toner cartridge can be replaced while a job is printing.
1. Open the dry ink/toner cover, located just above the press front door or cover.
2. Lay paper on the floor before removing the cartridge. This will allow any excess dry ink/toner to
fall on the paper.
3. Slowly remove the dry ink/toner cartridge by placing fingers under the end of the cartridge and
gently pulling it straight out. While pulling out, hold the bottom of the cartridge with your other
hand to give it support.
Ensure that you remove the same cartridge that matches the color as indicated in the message.
Xerox
®
Versant
®
4100 Press
User Documentation
249
Summary of Contents for Versant 4100 Press
