Xerox Telecopier 7033, Service Manual

Page: 166 / 286

2. Set up the terminal.
a. Using the left and right sides as lifting
points, remove the terminal from the
carton.
b. Position the terminal in the customer-
designated location.
NOTE: The table/stand for the terminal must
be capable of supporting 75 pounds and meet
the space requirements. A stand is available as
an option from Xerox.
3. Remove packing material.
a. Remove all tape from external covers.
b. Remove protective film from the
control panel.
c. Open printer cover and remove
packing material from roller.
Install the operator guide
1. Remove the operator guide from the
accessory bag.
2. Slide the guide into the holder located
below the paper tray.
Install the customer assistance label
USO:
1. Record the serial number and customer
assistance telephone number on the
customer assistance label:
a. Copy the serial number from the plate
located under the donor film cartridge
near the rear frame.
2. Also record the serial number in the “User
Handbook” on the page titled
“Requesting assistance.”
3. Install the customer assistance label.
a. Remove the protective cover backing
and carefully position the cover over
the label.
b. Place the label on the base of the
control panel.
RX:
Record all necessary details required by your
organization.
Connect the telephone handset and line cord
USO:
1. Install the telephone handset.
a. Remove the handset from the box and
place the handset on the cradle.
b. Insert the end of the telephone
handset card into the modular jack
marked TEL on the terminal rear cover.
2. Install the telephone line cord.
a. Insert one end of the telephone line
cord into the modular jack marked
LINE on the terminal rear cover.
b. Insert the other end of the cord into
the modular jack at the telephone wall
jack.
3. Verify telephone operation.
a. Lift handset and listen for a dial tone.
b. If no dial tone is heard, check the
connections. If checking the
connections does not resolve the
problem, refer to Service Call
Procedures.
c. Place the handset on the cradle.
RX:
1. Install the optional handset.
a. Connect the handset to the
appropriate connections on the
telephone line filter PWB.
2. Install the telephone line cord.
a. Connect the telephone line cord to L1
and L2 on the telephone line filter
PWB.
(RX 7033S only) Install control panel
1. Install the control panel overlay (if not
applied during pre-install).
2. Install the control panel mounting bracket
to the EMI shield and secure it with four
screws.
3. Attach the control panel to the mounting
bracket with three screws.
4. Connect the harness to the rear of the
control panel.
5. Install the rear control panel cover.
6/92
Telecopier 7032 / 7033 Service Manual 6-22
6.5.2
www.printcopy.info
www.printcopy.info