Xerox Phaser 8510MFP, Supplementary Manual

Page: 4 / 26

Copyright © 2006, by Xerox Corporaton. All Rights Reserved. 1 of 2 075-1018-00 Rev A
Phaser
®
8510/8560MFP
www.xerox.com/office/8510_8560support
Scanner Calibration Instructions
Perform the scanner calibration procedure if your scanner, document feeder, or document cover is
replaced. Scanner calibration adjusts the output quality of the front and back pages of 2-sided originals in
relation to each other.
This procedure should not be performed as part of normal system operation.
Starting the Calibration Procedure
1. On the control panel, press the System button.
2. Select
Information
, and then press the OK button.
3. Select
Troubleshooting
, and then press the OK button.
4. Select
Service Tools
, and then press the OK button.
5. Select
Calibrate Scanner
, and then press the OK button. Continue with the Document Glass steps.
Document Glass
1. Place the Scanner Calibration page on the document glass, with the top edge of the page toward the
left.
Note: Make sure the calibration page is aligned correctly. If the page is misaligned, the calibration
procedure will fail.
Calibrate the scanner using the Scanner Calibration page that came with your
replacement scanner, document feeder, or document cover. After you begin the
calibration procedure at the control panel, calibrate the scanner using a two-step
process:
■
The first step scans the calibration page from the document glass. Follow the
steps in the
Document Glass section. (For systems without a document
feeder, only use the steps in this section to calibrate the scanner.)
■
The second step scans the calibration page through the document feeder.
Follow the steps in the
Document Feeder section.