Xerox Phaser 8400, Service Manual

Page: 23 / 29

Phaser 8400/8500/8550/8560 Color Printer Service Manual 3-5
Error Messages and Codes
6.08 N/A Soft IDE drive general failure. Reseat IDE
cable and power cable. If problem
persists, replace the IDE drive. The
printer will work without the IDE drive. 6.808
07.01 Flutter only Soft Control Panel link is invalid or bad
parity. 16.1
07.02 Flutter only Soft Control Panel version mismatch. 16.2
08.01 Flutter only Soft Control Panel failed to initialize. 16.3
09.01 Flutter only Soft Control Panel data path failure. 16.4
10.01 Flutter then 10 blinks Hard PLD power control link down. 33.1
10.02 Flutter only Soft PLD power control link invalid,
mismatch error. 33.2
11.01 Flutter then 11 blinks Hard EEPROM read failure.
1. Check EEPROM orientation.
2. Replace EEPROM.
12.1
11.02 Flutter then 11 blinks Hard EEPROM write failure.
1. Check EEPROM orientation.
2. Replace EEPROM.
12.2
11.03 Flutter then 11 blinks Hard EEPROM re-read failure.
1. Check EEPROM orientation.
2. Replace EEPROM.
12.3
11.04 Flutter then 11 blinks Hard EEPROM data failure, mismatch error.
1. Check EEPROM orientation.
2. Replace EEPROM.
12.4
12.xx Flutter only Soft Configuration card test failure.
1. Check card orientation.
2. Reseat then replace the
configuration card.
NOTE Printer will work as a base model
(without networking) without the
configuration card (8400 only).
13.01 Flutter then 13 blinks Hard PHY reset failure, reset stuck low. 2.1
13.02 Flutter then 13 blinks Hard PHY ID error, mismatch error. 2.2
14.xx Flutter then 14 blinks Hard USB errors, N2280 netchip read, write,
and mismatch errors, POST hard
errors. 19.1
15.01 Flutter then 15 blinks Hard CPU interrupt error. 19.3
15.02 Flutter then 15 blinks Hard CPU interrupt error, missing CPU
interrupts. 19.4
15.03 Flutter then 15 blinks Hard CPU interrupt error, IRQ spurious
assertion. 19.5
POST Error Reporting Blink Pattern Definition Table (Continued)
8400
Error
Code
PS, PE and Control
Panel LEDs (for
8400) POST
Error
Type
Description
8500/
8550/8560
Error Code