Xerox Phaser 7300B, Service Manual

Page: 204 / 277

6-188 Phaser 7300 Color Printer Service Manual
Color Registration Plate Shutter (PL 5.1.11)
Note: The Color Registration Plate Shutter contains the “Color
Chip” and ADC Tag number. Perform the ADC
Calibration (see pg. 4-116) if you replace the shutter.
1. Carefully remove the shutter spring through the opening in the plate shutter.
2. Open the shutter plate to the full open position.
Caution: Be careful not to break the “T” shaped plastic guides
which can happen if lifting the plate shutter to far.
3.
Carefully lift the tabs on the right end of the shutter over the stopper and continue
to move the shutter toward the right of the printer.
4. Remove the shutter.
Reassembly
Note: Reverse these steps to install the shutter. Make sure that all
guide pins on the shutter plate are properly aligned when
reinstalling. Move the shutter to the fully closed position
then insert the shutter spring.
Caution: Clean the color chip with API to remove any oil that may
have been left by your fingers from handling the color
chip.
2
1
S7300-81