Parts List
Phaser 6020/6022 and WorkCentre 6025/6027 MFP
Service Manual
5-4
Using the Parts List
Only parts showing part numbers are available for ordering by support. Parts not showing part
numbers are available on the parent assembly.
•
Item:
The callout number from the exploded part diagram.
•
Name/Description:
The name of the part to be ordered and the number of parts supplied per
order.
•
Part Number:
The material part number used to order that specific part.
•
Parts identified throughout this manual are referenced
PL#.#.#
; For example, PL3.1.10 means the
part is item 10 of Parts List 3.1.
•
A Black triangle preceding a number followed by a parenthetical statement in an illustrated parts
list means the item is a parent assembly, made up of the individual parts called out in
parentheses.
•
The notation “
with X~Y
” following a part name indicates an assembly that is made up of
components X through Y. For example, “1 (with 2~4)” means part 1 consists of part 2, part 3, and
part 4.
•
An asterisk (*) following a part name indicates the page contains a note about this part.
•
The notation “
J1<>J2 and P2
” is attached to a wire harness. It indicates that connector Jack 1 is
attached to one end of the wire harness and connector J2 is attached to the other end that is
plugged into P2.
•
Fastener location and type are indicated using designators listed in the following table. Refer to
“Fastener Types” on page 4-4” for a complete list of fasteners used, and “Hardware Kit” on
page 5-98 for fasteners available in the Hardware Kit.
Designator
Fastener Type
E
E-ring
KL
K-clip
ST
Screw, self-tapping
SM
Screw, sheet metal
www
MK-Electronic
de
