Xerox Nuvera Digital Production System Paper, Paper Manual

Page: 32 / 80

X e r o x N u v e r a P a p e r G u i d e 2 - 1 0
M a n a g i n g y o u r p a p e r s u p p l y
before positioning the inboard paper guide.
– Always load tab stock with the tabs positioned at the trail
edge.
– Use care when positioning the trail edge guide against the
tabbed edge of the stock to prevent damage to the tabs.
NOTE: Use regular (forward, straight) collated tabs with lead edge
binders like the DS5000 and BFM.
– Refer to Appendix C, Printing with tabs , for more
information.
– Refer to Xerox Nuvera User Guide and Training Aid CD or
http://www.xerox.com for more information.
Inserter hints and tips
An inserter is a feeder module that is positioned between the print
engine and the finishing device.
An inserter allows you to insert preprinted, blank, or other stocks
into your documents. Stocks that are fed from an inserter do not
pass through the fuser.
Inserter trays are loaded and programmed in the same ways that
feeder trays are loaded and programmed.
Stock names
The system uses the stock name to locate stock in feeder and
inserter trays. If the same stock is programmed in a feeder paper
tray and an inserter paper tray, the system will choose the feeder
tray over the inserter tray.
To avoid using the wrong tray, the stock can be copied and
renamed with a unique name. The feeder and inserter can then
be programmed with one version or the other.
Stock orientation
Load inserter trays as you load feeder trays. Refer to the label in
the tray for help with orienting your stocks in the tray.
The Xerox Nuvera will allow you to stack printed jobs face up or
face down. The default is to print jobs face down, which is the
recommended orientation when using an inserter. If a job is
printed face up, sheets fed from the inserter may be oriented
incorrectly.
When printing from feeder and inserter trays, pay special attention
to stock orientation.