Xerox DP N24, System Administrator Manual

Page: 107 / 336

Parallel Menu
Chapter 3: Using the Control Panel
❖
3-43
Table 3.11 Parallel Menu functions
Menu Item and Function Keystrokes Display
Port Enable
Enable or disable the parallel port. The
available values are:
On*
Off
1. Press Menu Up or Menu
Down until you see:
M e n u s
P a r a l l e l M e n u
2. Press Item Up or Item
Down until you see:
P a r a l l e l M e n u
P o r t E n a b l e
3. Press Value Up or Value
Down until you see:
P o r t E n a b l e =
New Value
4. Press Enter . You will see:
P a r a l l e l M e n u
P o r t E n a b l e
5. Press On Line . You will see: R e a d y
Port Timeout
Set the time for determining when to end
an incomplete print job and poll the next
port in the polling sequence. The available
values are:
5 - 300 seconds (30*)
This item also causes an implicit job end
such as Control D in PostScript or <ESC>
E in PCL, and invokes the emulation
functions associated with this action (e.g.,
formfeed, reset, etc.).
The time changes incrementally by 1
second each time either Value Up
or
Value Down is pressed. Holding
down Value Up or Value Down
causes continuous scrolling through the
values.
1. Press Menu Up or Menu
Down until you see:
M e n u s
P a r a l l e l M e n u
2. Press Item Up or Item
Down until you see:
P a r a l l e l M e n u
P o r t T i m e o u t
3. Press Value Up or Value
Down until you see:
P o r t T i m e o u t =
New Value
4. Press Enter . You will see: P a r a l l e l M e n u
P o r t T i m e o u t
5. Press On Line . You will see:
R e a d y
Table 3.11 Page 1 of 2