OS/2 Warp V4.0 and OS/2 Warp Connect 3.0 Peer-to-Peer Network
38
❖
Quick Network Install Guide
OS/2 Warp V4.0 and
OS/2 Warp Connect 3.0
Peer-to-Peer Network
Quick Install Steps
1
Print the Configuration Sheet. Details are in this
document in
Appendix A: Print The Configuration
Sheet
.
2
Check the Configuration Sheet and verify that both
TCP/IP protocol and proper connector are enabled on the
printer.
3
Create a new printer to load print drivers. Details for this
are found in the
Technical Information Guide
.
4
Create a printer share and its access permissions (sharing
and connecting).
5
Start LPRPORTD/LPRMON, ping printer, open EPM and
send a print job to the printer.
6
Check the print job for print quality. If print quality
problems exist, use the print quality section of your
printer
System Administrator Guide
to correct the
problem.
7
If your print job did not print, see the Troubleshooting
section for your operating system in the
Technical
Information Guide
to correct the problem.
