6/98
Repair/Adjustment Procedures
4-28
Xerox DocuPrint N17 Service Manual
4.6.5 Tray Bottom
Removal
1 Remove the Front Tray Chute Assembly (
REP 4.6.4 Front Tray Chute Assembly).
2 Compress the Tray Bottom.
3 Compress the tab on the right limiting the Tray Bottom upward travel.
4 Raise the Tray Bottom to the upright position and pull the right pivot out of position.
5 Remove the Tray Bottom by pulling the Tray Bottom away from the left pivot.
NOTE: Be careful not to lose the springs when the Tray Bottom is decompressed.
Figure 4.6.5.1 Tray Bottom Removal
Replacement
1 Compress the Tray Bottom with the springs in position.
2 Perform the removal steps in reverse order.
4.6.6 Retard Assembly
Removal
1 Remove the Tray Bottom (
2 Press the Retard Assembly down to the level plane, and remove the Assembly by unclipping it
from the Tray Bottom.
SAS423F.CDR
sas423fa
www.printcopy.info
www.printcopy.info