6/98
Xerox DocuPrint N17 Service Manual
12-17
High Capacity Feeder Option
12.3.7 Elevator Belt (Rear)
Removal
1. Open the feeder drawer and remove all paper.
2. Disconnect the AC Power Cord from the High Capacity Feeder.
3. Remove the four screws that secure the Rear Access Cover. Remove the access cover.
4. Disconnect J5, J7, and J9 and slide the drawer fully open.
5. Release the latches on the drawer rails and remove the drawer from the cabinet.
6. Place the drawer on a suitable work surface to allow access to the rear drive assembly.
7. Remove the Elevator Motor Assembly (Refer to 12.3.6).
8. Remove the screw and clamp from the belt drive clamp (Figure 12.3.7.1).
9. Remove two retaining clips (Figure 12.3.7.1).
10. Remove lower Gear (Figure 12.3.7.1).
11. Slide upper Gear and Belt off the upper shaft (Figure 12.3.7.1).
12. Remove Belt.
Figure 12.3.7.1 Elevator Belt (Rear)
Replacement
1. Perform the removal steps in reverse order, but do not replace the elevator assembly in the cabinet
until the Belt Adjustment check is performed.
2. Check the Belt Adjustment.
7
8
9
9
10
11
rep_08
www.printcopy.info
www.printcopy.info
