![background image](http://html1.mh-extra.com/html/xerox/docuprint-n17/docuprint-n17_service-manual_4131577456.webp)
6/98
Duplex Module Option
10-12
Xerox DocuPrint N17 Service Manual
10.3.5 Connector Chute
Removal
1 Remove the Duplex Module (
2 Remove the one screw which secures the Connector Chute to the Duplex Module.
3 Press inward the two claws which retain the Duplex Harness Assembly to disengage and detach
the Duplex Harness Assembly from the Connector Chute.
NOTE: Leave the Duplex Harness Assembly detached.
4 Shift/pry the Connector Chute slightly to the right to disengage the pin in the inside of the right
end of the Connector Chute from the Duplex Module.
5 Pull the Connector Chute off the indentations of the Duplex Module.
Figure 10.3.5.1 Removing the Connector Chute
Replacement
Perform the removal steps in reverse order.
SAS486F
Pin
Claws
Duplex Harness
Assembly
www.printcopy.info
www.printcopy.info