6/98
Repair Analysis Procedures (RAPs)
7-78
Xerox DocuPrint N17 Service Manual
7.5.3 Image Quality Checkout
This procedure is used to check that the quality of the printed image meets the specifications. Refer to
Figure 7.5.2.2.
The Image Quality Checkout includes the following:
1) Solid Area Density
2) Background
3) Deletions
4) Fusing
5) Resolution
6) Registration (Lead Edge to Trail Edge)
7) Registration (Side-to-side)
8) Skew
9) Skips/Smears
10) Spots
11) Other Defects
Procedure
Use new paper, whenever possible, to check the image quality of prints. Make five (5) prints of the Print
Engine Controller Test Pattern, Procedure 5.2.4, and five (5) prints of the System Controller Test Pattern,
Procedure 5.2.5. Discard the first two prints and retain the remaining prints for image quality analysis.
Go to the Solid Area Density checkout.
www.printcopy.info
www.printcopy.info
