72
A Appendix
Installation Procedure
Additional memory goes into the controller board
right underneath a network expansion card
(optional). If your printer has a network expansion
card, remove it to get an access to the RAM slot.
For information on how to uninstall/re-install the
network expansion card, refer to the installation
guide provided for the network expansion card.
The following describes how to install additional
memory to the printer.
The printer has one slot for installing a memory
card. If you want to add memory when the slot
already has a memory card, replace the memory
card with the one with larger capacity.
WARNING
• This equipment has been designed to restrict
operator access to safe areas only. Operator
access to hazardous areas is restricted with
covers or guards, which would require a tool to
remove. Never remove these covers or guards.
Important
• Before plugging or unplugging the interface cable
connector, be sure to switch off the printer or unplug the
power cord from the power outlet. Plugging or
unplugging the connector when the printer is on can
cause printer failure.
1.
Switch the power off by pressing the power
switch on the front lower right of the printer to
the <O> position.
Unplug the power cord from the power outlet
and the printer.
2.
Remove the two screws that secure the rear
cover to the printer.
3.
Pull the rear cover forward and remove it
from the printer.
4.
Loosen the three screws that secure the
metal plate cover inside the printer.
5.
Pull the metal plate cover forward and
remove it from the printer.
Additional memory
Network expansion card
