The Document Company
XEROX
DC220/230ST Windows NT
®
4.0 NetBIOS/IP Quick Install
10.
Press
[Exit]
. The DC220/230 will reboot
and print a configuration sheet in approxi-
mately 3 minutes.
11.
Check the settings on the configuration
sheet against those that were entered.
12.
At the client, install print drivers and map
the printer in the usual manner. Refer to
the CentreWare manual,
Getting Started
with Print and Fax Services
for additional
information.
Additional information on this installation proce-
dure can be found in the DC220/230 System
Administration Guide.
6.
Enter the Host Name:
a)
Press
[Host Name]
, then press
[Edit]
and use the keyboard on the screen to
enter the Host Name for your network
(14 characters or less).
b)
Press
[Save]
.
7.
Enter the Printer Name:
a)
Press
[Printer Name]
, then press
[Edit]
and use the keyboard on the
screen to enter the Printer Name for
your network (15 characters or less).
b)
Press
[Save]
.
8.
Enter the Workgroup name:
a)
Press
[Workgroup]
, then press
[Edit]
and use the keyboard on the screen to
enter the Workgroup Name for your
network.
b)
Press
[Save]
.
9.
Press
[Save]
to exit the NetBIOS/IP
screen.
h)
Press
[Broadcast Address]
, then
press
[Edit]
and use the keyboard on
the screen to enter the Broadcast
Address you want your DC220/230 to
use.
Note:
The Broadcast Address is the address
where all the host bits are set to either zero (0)
or one (1).
i)
Press
[Host Name]
, then press
[Edit]
and use the keyboard on the screen to
enter the Host Name you want your
DC220/230 to use.
j)
Press
[Save]
.
k)
Press
[Save]
on the TCP/IP screen to
save all the settings.
4.
Access the NetBIOS/IP Network Setups
screens:
a)
Press
[NetBIOS/IP]
.
5.
Enable NetBIOS/IP:
a)
Press
[Enablement]
.
b)
Press
[Enabled]
.
©1998 Xerox Corporation
701P97990
Version 1.1, 5-98
For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797 Canada: 1-800-939-3769
