Xerox DocuColor 5000, Getting Started, Page: 32 / 38

DocuColor 5000 Getting Started 10
Get started now!
How to Power On/Off the Digital Press
Use the Power Switch to power
ON
or power
OFF
the Digital
Press.
How to Load Paper
You can load a wide variety of coated or uncoated standard paper
sizes and weights into the Paper Trays, ranging from 7.2 x 10.1
inch, Long Edge Feed (LEF) or Short Edge Feed (SEF) to 12.6 x
17.7” (LEF).
Acceptable weight ranges are from 60 to 300 g/m
2
. The weight
range of the paper loaded is shown on the Machine Status screen.
Perform the following steps to load paper:
NOTE: Many suppliers use arrows on the paper ream labels to
indicate the preferred side to image first. Use this side (as
indicated by the arrow) as equivalent to the seam side when
loading the paper.
1.
Pull out the tray slowly until it stops.
2.
Load the correct size paper into the tray in the correct
feeding orientation.
•
Load the paper seam side (the side on which the ream
of paper is sealed) up in all the trays.
• Do not load materials above the MAX line located on
the rear Edge Guide.
ON/OFF
ON
Press the Power Switch to the
ON
position to power ON
the Digital Press.
A screen message advises of a short wait while the
Fuser warms up and the Digital Press runs a system
check. You can program the Digital Press for a job
during this time and the printing process will start
automatically when the Digital Press is ready
.
OFF
Press the Power Switch to the
Off
position to power off
the Digital Press.
Allow the Digital Press to remain off for a minimum of 10
seconds before switching the power ON again
.