DocuColor 5000 Administrator Guide
3-42
3. Profiles
Decurler Profile procedure
IMPORTANT!
Before using this procedure, use a Decurler A-D
setting to eliminate the curl in our print output; refer to page 3-
34. If a Decurler A-D setting is unsuccessful in eliminating your
curl, evaluate the curl on the output prints (page 3-36). Once you
have measured and recorded the curl on your output, then you
can perform this procedure.
1.
Load a specific Paper Tray with the paper you wish to use
for a job. Make the correct paper selections on the Tray
Properties window for the paper being used and run a few
test prints.
a. If there is too much curl,
save the stack
and continue
to the next step.
b. If the test prints are acceptable, you are finished.
NOTE: For the purpose of this procedure, Paper Tray 1 is used as
the example.
2.
Select one of these Decurler A-D settings from the Tray
Properties window.
3.
Run the same print job again, and retrieve the output from
the exit area of the digital press.
Summary of Contents for DocuColor 5000
