Detailed Specifications
Xerox Color
®
C60/C70
Customer Expectation and Installation Guide
16
o
Pre-printed Tabs cannot be punched
•
The GBC
®
AdvancedPunch™ is supported by all color servers.
•
The GBC
®
AdvancedPunch™ supports media from 75 to 216 gm
2
, coated and uncoated.
o
ProClick die supports media from 75 to 203 gm
2
•
The GBC
®
AdvancedPunch™ supports tab stock no wider than 9”; oversized tabs may be damaged..
o
Stacking may be misaligned on jobs containing tab stock; these jobs will require additional
jogging before final finishing.
•
The GBC
®
AdvancedPunch™ is able to bypass all coated and uncoated media sizes printed on the Xerox
560/570 Digital Color Press.
•
Hole punch position from edge of paper is not adjustable.
•
Opening the door of the GBC
®
AdvancedPunch™ while the machine is running will cause the machine to jam
and shut down.
•
Gloss coated media may not run as reliably as uncoated paper. Typically, coated papers and high area
coverage exhibit increased variability in paper handling due to lower coefficients of friction. This may result in
varied punch registration and increased jam rates.
•
Punching 8 ½ x 11 duplexed coated stock using the GBC 3-hole punch (008R13072) is not recommended
due to greatly increased paper jams.
•
Pre drilled stock LEF is not supported by The GBC
®
AdvancedPunch™, however predrilled stock may be run
using SEF
•
Due to the nature of punching holes, each punched sheet is slightly deformed, and when stacked, the edge
with the holes will have an increased height as compared to the non-punched edge.
o
Reduced stack quality may be experienced due to variability in the punch hole formation.
o
The stack height can be effected by many factors, such as: paper type, quality, weight and
curl, as well as die type, age and condition. Paper curl is best when it has a slight downward
curl on the edges. This can be adjusted by the operator while running prints.
•
A4 and LTR punch units are not the same; therefore, A4 and LTR die sets are not interchangeable.
•
The LTR punch unit will be shipped with the 19-hole punch die.
•
The A4 unit will ship with the 21-hole punch die.
•
Additional punch dies are available for order (see below)
•
Up to 3 additional die sets can be stored inside the GBC
®
AdvancedPunch™.
•
Punch Dies
The GBC
®
AdvancedPunch™ is capable of punching a variety of hole-punch patterns by simply changing the
punch die. Punch dies can be changed in seconds without tools. The punch dies currently available are listed
below. Each die set has a 90 day warranty from date of purchase.
•
In the Western Hemisphere (8 ½ x 11 inch) punch dies are ordered using the Supplies ordering process; in
Europe (A4) punches are ordered through sales representatives; please check for availability.
•
A4 and Letter version die sets are not interchangeable.
•
Please note: Punch die life will be increased if the wick material is lightly oiled every 50,000 punch cycles
(approximately every month) with quality machine oil such as 3-in-1 Oil. Small deposits of oil will be observed
around the perimeter of the punched holes until the excess oil is absorbed (usually within 20 sheets).
