Xerox C315, User Manual

Page: 46 / 376

Setting up the printer to fax
• The following connection methods are applicable only in some countries or regions.
• During the initial printer setup, clear the fax function check box and any other function you plan to set up later,
then select C Coonnttiinnuuee.
• If the fax function is enabled and not fully set up, then the indicator light may blink red.
W Waarrnniinngg::
Do not touch cables or the printer in the area shown while actively sending or receiving a fax.
S E T T I N G U P T H E FA X F U N C T I O N
1. From the control panel, navigate to:
SSeettttiinnggss >> D Deevviiccee >> PPrreeffeerreenncceess >> RRuunn IInniittiiaall SSeettuupp
2. Turn off the printer, wait for about 10 seconds, then turn on the printer.
3. From the Before You Begin screen, select C Chhaannggee tthhee SSeettttiinnggss aanndd C Coonnttiinnuuee w wiitthh tthhee W Wiizzaarrdd.
4. From the Fax/Email Server Setup screen, enter the needed information.
5. Finish the setup.
Using the fax setup wizard in the printer
• This wizard appears only when analog fax is not yet set up.
• This wizard only sets up the analog fax. To setup other fax modes, go to Settings > Fax > Fax Setup.
• Before using the wizard, make sure that the printer firmware is updated. For more information, see Updating
Firmware .
1. From the home screen, touch FFaaxx.
2. Touch SSeett uupp nnoow w.
3. Type the fax name, and then touch N Neexxtt.
4. Enter the fax number and then touch D Doonnee.
46
Xerox
®
C315 Color Multifunction Printer User Guide
Set up, Install, and Configure