Xerox B210, Service Manual

Page: 29 / 142

July 2019
2-8 Xerox® B210 Service Manual
07-500 , 07-530
Initial Release Status Indicator RAPs
07-500 Manual Feed Slot Paper Empty RAP
BSD-ON: BSD 1
The Registration Sensor failed to detect paper in the Manual Feed Slot.
Initial Actions
Ensure that paper is loaded in the tray. Clear any jammed sheets. Refer to Section 7: Trouble-
shooting, in the Xerox® B210 User Guide for detailed instructions on clearing paper jams.
Procedure
Check the Registration Sensor actuator. The actuator moves freely and is undamaged.
Y N
• Verify no contamination is present.
• Install a new Registration Sensor Actuator, PL 4.4 Item 19 .
The sensor signal changes.
Y
N
Check for 3.3 VDC on the Main PWB. The voltage is present on the Main PWB.
Y N
• Install a new HVPS PWB, PL 4.1 Item 2 .
• Install a new Main PWB, PL 1.1 Item 7 .
Install a new Feed Sensor PWB, PL 4.4 Item 20 .
Perform SCP 4 Final Actions.
07-530 Paper Feed Fault - Manual Feed Slot RAP
BSD-ON: BSD 1
The lead edge was not detected by the Paper Feed Sensor.
Initial Actions
Clear any jammed sheets. Refer to Section 7: Troubleshooting, in the Xerox® B210 User
Guide for detailed instructions on clearing paper jams.
Procedure
Check the position of the jammed sheet. The lead edge reached the Retard Roll.
Y N
• Check for an open or short circuit.
• Install a new Feed Sensor, PL 4.4 Item 20 .
Check the feed again. The clutch engages.
Y N
• Check for an open or short circuit.
• Install a new Feed Clutch, PL 4.1 Item 5 .
Perform SCP 4 Final Actions.
Check the Paper Feed actuator.
The actuator moves freely and is undamaged.
Y N
Install a new Feed Sensor Actuator, PL 4.4 Item 18 .
Inspect the Feed Sensor for damage. The sensor is OK.
Y N
• Check for an open or short circuit.
• Install a new Feed Sensor PWB, PL 4.4 Item 20 .
Check the circuit of the Feed Sensor PWB.