Xerox ApeosPort-II 3000, User Manual

Page: 313 / 619

Fax Mode Settings
311
Sys
tem
S
et
tin
g
s
10
Edge Erase - Left & Right Edges
Specify an amount of border erased from the original in left and right directions. Specify a
value in the range from 0 to 20 mm, in 1 mm increments.
Reduce 8.5x11" Original to A4
When [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto %], you can set
whether to reduce 8.5 x 11”
size to A4 , while scanning the original.
Pseudo-Photo Gradation Mode
You can set the toning method for photo originals. To get closer to photo image quality, select
the handling of intermediate tones (gray). You can select from [Error Diffusion] and [Dither].
Box Selector - Line Setup
Select whether to use the Box Selector - Line Setup feature.
The Box Selector - Line Setup feature allows you to classify received documents by line type
and store them in specified mailboxes.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.268).
„ Cancel Job
The stored data is discarded.
„
Run Job
The stored fax data is printed.
Maximum Stored Pages
Set the maximum number of fax pages that the machine can store. You can specify a value in
the range of 1 to 999.
Mailbox Receive Display Priority 1 to 3
Set the priority to display the fax document information received using mailboxes. For
instance, when using Network Scanner Utility2, the fax information is displayed in the
[Recipient] section of the document list screen.
There are the priority levels from 1 to 3. All priority can be set, however, if you want to display
only one priority level, make the settings of all priority levels the same.
Note • This feature is not available for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Direct Fax
Set whether to allow the use of Direct Fax. When selecting [Disabled], the Direct Fax feature
cannot be used.