Xerox AltaLink 8035, Installation And Configuration Manual

Page: 9 / 66

2
Preparation
This section explains the preparation and resources required to install the Smart Card feature.
Configuration Checklist
The following items are required to complete the installation:
Status Summary
1. Obtain the IP address or Host Name for each applicable Windows Domain Controller.
2. If Domain Controller Certificate validation is required, obtain the DC certificate for each ap-
plicable controller, including all intermediate certificates up to the root certificate.
Note
This procedure typically is required only for Smart Card.
3. If Online Certificate Status Protocol (OCSP) is available, obtain the IP address or Host Name
for the OCSP server.
4. If a software upgrade is required, obtain and install the required software release.
5. Mount the Smart Card Reader to the MFD and connect the USB cable to one of the rear ports.
Refer to
Connect the USB Smart Card Reader to the MFD .
6. Install the Smart Card software Feature Enablement Key. Refer to Enter the Smart Card En-
ablement Key .
7. Configure Smart Card Authentication, the optional NTP, and the optional Alternate Login.
Refer to
Configuring the Smart Card .
8. Install any required certificates and configure validation settings. Refer to Configure a Security
Certificate .
9. Configure the MFD LDAP settings. Refer to Configure Acquiring Logged-In User's Email Address .
2-1 Xerox ® AltaLink ® Series
Smart Card Installation and Configuration Guide