6
Phaser 3400 Personal Laser Printer
TCP/IP Configuration
1.
Install the driver as described on page 4.
2.
Click
Start
, select
Setting
, and then click
Printers
.
3.
Right-click on the Phaser 3400 printer and click
Properties
from the popup menu.
4.
On the
Details
tab, click the
Add Port
button.
5.
Verify that
Network
is the port that is selected.
6.
Either manually type in the network path or select it as follows:
a.
Click the
Browse
button.
b.
Double-click the server to which the printer is attached.
c.
Select the Phaser 3400 printer (or the share name that was designated by the
network administrator).
d.
Click the
OK
button.
Note
If you are not sure which server the Phaser 3400 printer is attached to or if the
Phaser 3400 printer is not selectable on the server, contact your network
administrator for support.
7.
When the network portion of the
Add Port
dialog box shows the path, click the
OK
button.
8.
The
Details
tab should now display the network path for
Print to the Following Port
.
Click the
Apply
button.
9.
When you see the
Fonts Downloaded to this printer while connected to LPT1 may be
lost
message, click the
OK
button. You may need to resend the fonts again on \\
your
server name
\
your
printer name
.
10.
On the
General
tab, click the
Print Test Page
button.
Macintosh
Setting up the Macintosh Ethernet port for TCP/IP
When using OS 8.5 or higher, you can use TCP/IP to print from your Macintosh. If your
Macintosh is not already set up for TCP/IP, perform the following procedure:
1.
From the
Apple
menu, select
Control Panels
, and select
TCP/IP
.
2.
From the
Connect via
menu, select
Ethernet
.
3.
Specify how the Macintosh will obtain its IP address:
Manually
or by
DHCP
.
4.
If you select
Manually
, specify the IP address in the dialog box.
5.
Close the dialog box and click
Save
for changes to take effect.
