Xerox 2101, Getting Started Manual

Page: 11 / 12

Xerox 2101
Xerox 2101 2-3
GETTING STARTED
·
If jobs in the RIP queue are merged and finishing is applied
to the merged job, not all the pages in the job may print
and/or the desired finishing may not be applied. Before
merging the jobs from the RIP queue, ensure that all the job
properties (plex, finishing, etc.) are the same for all jobs
including the final merged job.
·
It is recommended that jobs should be merged from the
Spool (Hold) queue. The job properties (plex, finishing, etc.)
of the merging jobs should be the same. Apply the desired
job properties to the merged job.
·
When using the Impose feature for a PDF job or a one page
document, if 2-up Saddle or 2-up Perfect are selected,
change the paper stock to 8.5x11 before closing
DocBuilderPro. Load 8.5x11 stock short edge feed (SEF). If
the paper stock is left at 8.5x11P, the job will fault and you
will not be able to print it.
· Tray 7 Restrictions: Sheets fed from Tray 7 (Interposer) will
not be punched. Solution: Use pre-punched stock in Tray 7,
if job requires punched paper.
· Feeding A4 Premier TCF heavyweight stock from Tray 7
may result in excessive paper jams.
· Under the Annotations feature, the word "Circular" is
incorrect. It should be labeled "Circulate”.
· Under the Annotations feature, no conflict checking exists.
Pay special attention when utilizing this feature as it is
possible to “stack” annotations on top of one another.
Printer Drivers
·
In all Microsoft Windows printer drivers the Two-Way
Communication feature in the Installable Options tab of the
Properties window is not available. You must set Installable
Options manually as described in the
Fiery EX2101 Printer
Control Getting Started document. Note that in Microsoft
Windows NT 4.0 the installable options are set in the Device
Settings tab of the Properties window.
·
The Macintosh version OS X uses a different method for
loading drivers than the OS 9x. Please follow the OS X
driver installation instructions.