Xerox 2101, Configuration Manual

Page: 72 / 192

4
4-16 Performing Setup from the Control Panel
Protocol Setup options
AppleTalk Zone
List of zones
The Fiery EX2101 searches the network for AppleTalk zones in your network segment.
Scroll through the list to select the AppleTalk zone in which you want the
Fiery EX2101 to appear. If your segment has only one zone, the Fiery EX2101 is
assigned to that zone
automatically.
The message “No AppleTalk zone found” may mean your network has no zones, or the
network cable is not connected (see
Appendix A ). Choose OK to dismiss the message.
TCP/IP Setup options
When you set an IP address, subnet mask, or gateway address for the Fiery EX2101
during Setup, you can allow the Fiery EX2101 to get these addresses automatically
from a DHCP or BOOTP server. Turn on or restart the Fiery EX2101 and allow it to
reach Idle. Make sure the DHCP or BOOTP server is running, and then perform
Fiery EX2101 Setup.
To configure the Fiery EX2101, choose each protocol and enter the settings for that
protocol. You can enable AppleTalk, TCP/IP, and IPX/SPX communication
simultaneously.
Network Setup
Protocol Setup
AppleTalk Setup
Enable AppleTalk
Yes/No [Yes]
Select Yes if you have an AppleTalk network connected to the Fiery EX2101. This
setting enables the Fiery EX2101 to communicate over AppleTalk networks.
To configure the Fiery EX2101 for TCP/IP, choose TCP/IP Setup.
Choose Ethernet Setup and enter the appropriate settings. Choose each network
type you use (Ethernet) and enter the appropriate settings.
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup
Exit Protocol Setup
AppleTalk Setup
TCP/IP Setup
IPX/SPX Setup
Protocol Setup