Rover User Manual Version 3.0
31
Other Commands
Below is a list of other commands that can be sent via Iridium or Bluetooth to acquire additional
information, or configure the Rover. Remember to add the $ symbol ahead of any commands.
Iridium or Bluetooth
Command
Parameters
Description
ver
---
Show hardware and firmware versions (V-Type message)
Status
---
Show uptime/current timer mode/volts/orientation
startmsg
---
Combination Ver/Timer/Short Settings message
sysInf
---
GPS/Ird summary (I-Type message)
scm
---
Status Change Message (S-Type message)
FactoryDefaults
---
Set all configuration to defaults and reset device
btPwr
1/0
Bluetooth power On/Off
batt
---
Show battery status
settings
---
Show all settings
stats
---
Show statistics (since last powerup/reset)
statsL
---
Show Lifetime Statistics
switch
X 1/0
Switch component X On/Off. No parameter lists components
MsgEnable
timer#
m1,m2,etc
Set & Show which messages are enabled for each Timer
ReportHour
Hour (0 – 23) Set/Show Daily Reporting Hour offset from UTC
RepMinute
X (Minutes)
Minutes offset past the hour for GPS/Iridium
WCEnable
1/0
Watch Circle Enable/Disable
WCInner
X
Watch Circle percent of radius for elevated GPS monitoring
ResetNow
---
Restarts the system. The effect is the same as restarting via the
magnet
Bluetooth
btpcycle
---
Power cycle Bluetooth
btName
Insert Name
Set Bluetooth name for the Rover, changes after $btpcycle
fdumpall
---
Print out Flash Memory of the Rover (Bluetooth Only)
