Xenon 1900, User Manual

Page: 97 / 356

3 - 19
Reset Scanner and Base/Access Point
Once the power level is set, you must scan the Reset Base bar code and
wait for the scanner to unlink and relink to a base or an Access Point. Once
that is done, scan the
Reset Scanner bar code and wait for the base or
Access Point to unlink and relink to the scanner.
Batch Mode
Batch mode is used to store bar code data when a scanner is out of range of its
base or Access Point, or when performing inventory. The data is transmitted to
the base or Access Point once the scanner is back in range or when the records
are manually transmitted.
Note: Batch mode has limitations when using multiple scanners to one base or
Access Point. If a cordless system is being used in "multiple link mode,"
where up to 7 scanners are to be connected to one base or Access Point,
some accumulated or batched scans could be lost if scanners are
constantly being moved in and out of range.
Automatic Batch Mode stores bar code data when the scanner is out of range
of the base or Access Point. The data is automatically transmitted to the base
or Access Point once the scanner is back in range. When the scanner’s buffer
space is full, any bar codes scanned generate an error tone. In order to scan
bar codes again, the scanner must be moved back into range of the base or
Access Point so data can be transmitted.
Inventory Batch Mode stores bar code data, whether or not you are in range of
the base or Access Point. To transmit the stored data to the base or Access
Point, either place the scanner in the base, or scan
Transmit Inventory Records
(page 3-24). When the scanner’s buffer space is full, any bar codes scanned
generate an error tone. In order to scan bar codes again, the data must be
transmitted to the base or Access Point. Once the data is transmitted, it is
cleared in the scanner.
Persistent Batch Mode is the same as Inventory Batch Mode, except that once
the data is transmitted to the base or Access Point, it is retained in the scanner.
If you want to transmit more than once, you can do so using this mode. In order
to clear the scanner’s buffer, you must scan
Clear All Codes (see page 3-24) .
: * : R E S E T _ . ³
Reset Scanner
Reset Base