19
twenty4 series
EN
Warnings and safety notes
Operation of the model is performed solely at the risk of the operator. Only a careful and deliberate operation
protects against physical injury and damage to property.
Handling precautions for batteries or rechargeable batteries
• Keep batteries away from children! Never let batteries unattended, as they can be swallowed by children
or pets!
• Use only the recommended or equivalent type of batteries / rechargeable batteries.
•
WARNING:
do not expose batteries / rechargeable batteries to heat or throw into fire -
fire or
explosion hazard!
•
WARNING:
insert batteries / rechargeable batteries with the correct polarity, no short-circuiting -
fire or explosion hazard!
• If possible, always replace all batteries at the same time, never use new and used batteries and batteries
with different charge levels simultaneously.
• Do not use defective or damaged batteries or rechargeable batteries – fire hazard! Risk of chemical burns
on contact with skin, use protective gloves!
•
WARNING:
Do not attempt to recharge non-rechargeable batteries in a charger -
fire or explosion
hazard!
• Remove the rechargeable batteries from the device before charging.
• Charging may take place only with a suitable charger for the type of battery on a fireproof surface and
under constant adult supervision – fire hazard!
• Immediately remove used batteries from the devices.
•
NOTE:
NiMH batteries must be checked at least every 3 months and, if necessary, recharged, other-
wise because of the typic self-discharge they may get deep discharged and damaged! Therefore, better
use so-called RTU batteries with a very low self-discharge.
•
NOTE:
note the specified storage voltage for lithium batteries. Is a completely full or empty lithium
battery time stored for a longer time, it can be damaged.
The XciteRC Modellbau GmbH & Co. KG cannot monitor the proper use of the battery or batteries you use,
therefore, the warranty is excluded due to incorrect charging or discharging.
The remote control system
Here you get an overview of the remote control system of your Twenty4 and its various features and settings.
Before the first flight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bottom of
the transmitter and insert three AA batteries (or rechargeab-
le batteries) into the battery compartment of the transmitter.
Pay attention to the correct polarity!
• Close the battery compartment cover and turn on transmit-
ter – push ON / OFF switch in position I.
• Both LED’s must lit (red and green).
NOTE:
If the green
LED is flashing, the model may not be started –
crash ha-
zard!
Change transmitter batteries immediately (or charge
batteries).
• Pay attention to the LED’s also during operation. If only the
green LED flashes, stop driving as soon as possible. If both
LED’s flashing, stop immediately and replace transmitter
batteries (or recharge the batteries).
+
-
+
-
+
-
