XciteRC PARACOPTER RTF, Manual

Page: 26 / 56

26 PARACOPTER
Battery charging
Insert the drive battery
• Pull the locking lever to open the battery compart-
ment on the underside of the chassis.
• Pull the plug out and connect it to the drive battery.
• Now thread the plug fi rst, then the battery into the
chassis as shown in the fi gure.
• The battery compartment must be closed with an
audible “click”, so it cannot suddenly open during
the fl ight.
Charging the Battery:
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
Place the charger to a suitable, non-fl ammable surface. Connect the charger to a suitable power source. The
PARACOPTERs battery is equipped with an XH balancer connector. Before starting the charging process,
read the instruction manual of your charger used.
The remote control system
Here you get an overview of the remote control system of your PARACOPTER and its various features and
settings. Before the fi rst fl ight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in the lower position.
• Now open the battery compartment cover on the back of the transmitter and insert four AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter. Pay attention to the correct
polarity!
• Close the battery compartment cover and turn on transmitter – push ON / OFF switch upwards.
• The POWER LED must lit red.
• WARNING: If the POWER LED is fl ashing, supported by a beep, the model may not be started –
crash hazard! Change transmitter batteries immediately (or charge batteries).
• Pay attention to the POWER LED and the beeper also during operation. In this case, land immediately and
replace transmitter batteries (or recharge the batteries).
Transmitter
1
2 3
EN