16
XciteRC Flybar 185M Coax
EN
The remote control system
The remote control system
Here you get an overview of the remote control system of your XciteRC Flybar 185M and its various features
and settings. Before the fi rst fl ight, you should absolutely have read and understood all these functions and
settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Remove the srew and
slide the cover down (1). Insert four AA batteries into the battery compartment of the transmitter (2). Pay
attention to the correct polarity!
Battery cover
4x 1.5 V AA
batteries
+
-
+
-
+
-
+
-
1
2
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• When the POWER LED is fl ashing, move the left throttle lever to the top position, then back to the bottom.
The POWER LED will light constantly. This safety circuit prevents the rotor may start after turning on the
helicopter.
• The POWER LED must lit.
Attention:
if the POWER LED fl ashes or does not light at all, the model may
not started –
crash hazard!
Change transmitter batteries immediately.
•
WARNING:
check the POWER LED also during operation. If the POWER LED starts to blink, stop
operation, switch the model off and replace the transmitter batteries –
crash hazard!
•
ATTENTION:
The maximum range of the remote control system is about 25 meters, do not fl y
farther away under any circumstances! If the XciteRC Flybar 185M gets out of range, the fail-safe function
is activated and turns off the motor.
Transmitter
Trim button
left/right
Speed
Throttle
lever
Direction
lever
ON/OFF-Switch
POWER-LED
Reset:
Press both trim buttons
for approx. 3 seconds,
when the POWER-LED
flashes 3 times all
calibrations return to zero.
USB socket
Summary of Contents for Flybar185 CoaxM
Page 21: ...21 XciteRC Flybar 185M Coax EN ...
Page 34: ...34 XciteRC Flybar 185M Coax ...
Page 35: ...35 XciteRC Flybar 185M Coax ...
