XciteRC 30201000 Sand Rail, Manual Manual

Page: 23 / 56

23 Sand Rail
EN
Chassis tuning guide
steering arm (30201011) press against the front uprights (30201012) which may damage the steering
servo!
-
+
+
+
After the ride:
1. Switch OFF the vehicle first, then the transmitter (ON/OFF-switch in position O).
OFF
2. WARNING: disconnect the drive battery and remove it from the model – fire hazard!
WARNING: the motor of the Sand Rail may get very hot during operation. Allow to cool down minimum 20
minutes before the next start to avoid damage.
Fire hazard!
Chassis Tuning Guide
On your Sand Rail chassis two parameters can be adjusted: the toe of the front axle and the camber of both
axles.
Toe-in:
the setting is done via the steering linkage. More toe-in gives a
better directional stability, but also poorer turn in at corner entry,
and generally a less direct steering.
More toe-out effects a direct response to steering commands
and more aggressivity at corner entry, but is also more difficult
to control.
A neutral setting reduces tire wear and gives a neutral handling.
Front Turning Linkage Set
Front Turning Linkage Set
toe-out
toe-in
toe-in
toe-out
zero toe
zero toe