18
XciteRC Flybarless 245 3D Brushless
EN
Getting started
Introduction
As you are about to see, the Xcite
Flybarless 245 3D Brushless
truly is an ultra micro heli experi-
ence unlike any oth er. Its advanced flybarless design reduces drag on the rotor head and more im-
portantly, under the precision in the three-axis gyroscope complement of self-control, it greatly in-
creases stability of the body. This, com
bined with its exceptionally lightweight airframe, delivers a
level of power and responsiveness that eclipses that of any ultra micro heli you have flown before.
Before you take the first flight, please take time to read through this manual. It contains important pre-flight
information as well as useful tips on binding your transmitter that will help ensure your first flight is a great one.
Specifications
Length
293 mm
High
87.5 mm
Weight
79 g
Main blades length
113 mm
Main blade diameter
249 mm
Tail rotor diameter
38.4 mm
Battery
7.4 V 450 mAh 25C
Flight time
approx. 4 - 5 minutes
Battery charging
NOTE:
Only use the charger delivered with the helicopter.
WARNING:
connect the charger only to a wall socket with 110-230 V AC voltage at -
risk of fire!
• Connect the balancer cable of the battery to the terminal of the charger
WARNING:
the balancer connector is polarized. Pay attention to the lateral chamfers and not use force
-
fire or explosion hazard!
• While charging the charging indicator light shows red. When the battery is full, the light turns green.
• The charger can charge two 1S batteries at the same time with the otional wiring.
First Flight preparation
Make sure the battery power is full for both transmitter and helicopter.
WARNING:
check the selected model memory of your XRC-6S transmitter, „HCP 100S“ is the correct
memory - otherwise the model may react uncontrollable at your commands -
crash hazard!
For chan-
ging the model memory please read the transmitters manual.
• Before open the power of TX, please make sure that the TH. Stick is in bottom position and the switch of
TH.HOLD and 3D mode in back position (back cover direction).
• Make sure the TX is binding with helicopter, or please rebind them.
• Please switch on the transmitter first, then connect the battery with the RX board on helicopter to bind
with the transmitter. When switching off, please cut the power of helicopter first, and then turn off the TX.
•
ATTENTION:
please pay attention to the saftey instructions at the beginning of this manual! Flying
in a suitable area, away from people, cars, electric pylon, pool and so on.
