10
Set Up Procedure for PLASMA Cutting
Razor
Cut
RAZOR CUT45
(1)
Connect the SC80 Plasma Torch to the machine. Insert the torch connection into the torch connection
receptacle at the front of the machine and screw up hand tight.
Caution:
Be careful not to bend the pins located inside the torch connector.
(2)
Connect the earth lead to the output terminal of the machine and tighten.
(3)
Connect the air supply to the air connection located at the rear of the machine.
Turn on the air supply
(4)
Connect the machine to the correct power supply and switch on the machine using the on/off switch
located at the rear of the machine.
(5)
Select 2T / 4T operation
Operating procedure using the 2T / 4T Function with SC80 torch.
Set torch operation 2T / 4T.
• When 2T operation is selected press trigger Arc starts, release trigger Arc stops.
• When 4T operation is selected press and release trigger Arc starts,
press and release trigger Arc stops.
(6)
Set amperage dial.
1.
Connect the SC80 Plasma Torch to the machine.
Insert the torch connection into the torch
connection receptacle at the front of the machine
and screw up hand tight.
2.
Connect the earth lead to the output
terminal of the machine and tighten.
(1)
Connect the SC80 Plasma Torch to the machine. Insert the torch
connection into the torch connection receptacle at the front of the
machine and screw up hand tight.
Caution:
Do not to bend the pins located inside the torch connector.
(4)
Connect the machine to the
correct power supply and switch
on the machine using the on/off
switch located at the rear of the
machine.
(3)
Connect the air supply to the
air connection located at the rear
of the machine. Turn on the air
supply.
(5)
select 2T or 4T torch control
(2)
Connect the earth lead to the
output terminal of the machine and
tighten.
(6)
Set the amperage dial
Summary of Contents for Razor Cut45
Page 19: ...19 NOTES RazorCut RAZOR CUT45...
