Boosting a Vehicle’s Engine
18
To boost a vehicle or boat engine:
1.
Turn off the vehicle or boat ignition and all accessories.
2.
Engage the park or emergency brake and place the
transmission in park for an automatic or neutral for a
manual.
3.
If boosting a boat engine, purge the engine compartment
and bilge of all fumes before boosting.
4.
Position the XPower Powerpack on a flat, stable surface
near the battery and away from all moving parts of the
engine.
Ensure that the Boosting Power Switch is OFF.
5.
Connect the red positive (+) clamp of the cables to the
positive (+) terminal of the engine battery.
The battery’s positive terminal is usually larger in
diameter than the negative terminal. In most vehicles, the
battery’s positive terminal has a red wire connected to it.
6.
Connect the black negative (–) clamp of the cables to the
engine block, cylinder head, or other stationary heavy
metal part of the motor.
If the Red Boosting Connection LED illuminates and the
XPower Powerpack’s alarm sounds, then reverse polarity
has been detected. Correct polarity must be established
before proceeding. Disconnect the boosting clamps from
the vehicle’s battery and redo steps 5 and 6 in this
procedure.
WARNING: Fire hazard
Boosting cable clamps’ connection to the vehicle’s battery
terminals must be positive to positive (red clamp to battery “+”) and
negative to negative (black clamp to battery “–”). A reverse polarity
connection (positive to negative) may cause damage to the unit and/
or create a sparking/explosion hazard.
Important:
Closely follow these instructions for boosting your
vehicle as they may be different from the instructions supplied
with other boosting products or boosting cables.
XPower_PP_200_Plus.book Page 18 Thursday, October 20, 2005 1:28 PM
Summary of Contents for XPower Powerpack 200 Plus
Page 1: ...by XPower Powerpack 200 Plus Owner s Guide ...
Page 20: ...8 ...
Page 44: ...32 ...
Page 54: ...42 ...
