![background image](http://html1.mh-extra.com/html/xantrex/truecharge-2-series/truecharge-2-series_owners-manual_3301112024.webp)
12
Truecharge2 Series Battery Charger Owner’s Guide
Preparing For Installation
Wiring Requirements
NOTES:
•
Wiring and fuse sizes are governed by electrical codes and standards.
Different requirements apply in different countries and to different
types of installations, for example, boat, home or RV. It is the
responsibility of the installer to ensure that each installation complies
with all applicable codes and standards.
•
Ensure that wires and fuses or breakered disconnects are correctly
sized. Maximum continuous DC current available from the charger
may be an additional 6–10% above the nominal current rating of the
charger.
Figure 6
Mounting Orientations (Vertical)
Figure 7
Ventilation Clearance
(c)
(d)
Vertical Wall Mount
(Rear panel facing
down or up) - this
orientation is allowed
in locations that are
always dry but is
approved for marine
installations only with
additional drip
protection.
(c)
(d)
6 cm.
(2.5 in.)
10 cm.
(4 in.)
ELECTRICAL SHOCK AND FIRE HAZARD
Do not operate the battery charger with damaged or substandard wiring.
Make sure that all wiring is in good condition and is not undersized. See
notes below.
Failure to follow these instructions will result in death or serious
injury.
TC2 204060 Series BattChg Owners Guide.book Page 12 Friday, July 8, 2011 11:44 AM