
XT-4K-VIP-TX/RX
QUICK REFERENCE GUIDE
®
© 20
19 XANTECH
®
is a registered trademark of Nortek Security and Control, LLC.
10023196_RevA10_Quick_Reference_Guide_Xantech_XT_4K-VIP_TXRX_1005_WEB
XT-4K-VIP-RX Front Panel
15
14
13
12
11
1
Type-A USB ports - USB 2.0 connections for USB/KVM routing within VIP system
2
IR Flasher (IR output) - 3.5mm mono jack – R
outes IR from any XT-4K-VIP-TX (IR IN) allowing local equipment
control. Use Xantech 12V IR emitters (sold seperately)
3
IR IN (IR input) – 3.5mm stereo jack. Transmits IR to currently selected XT-4K-VIP-TX transmitter allowing routed
IR control of sources. Please use a Xantech 12V IR Receiver (sold seperately). When using the Xantech IR
Receiver (optional) ensure cable direction is correct
4
Transmitter Select Up/Down - Used to scroll through sources (XT-4K-VIP-TX), setup XT-4K-VIP-RX manually, and
apply ‘Programming mode’
5
Transmitter ID status window - Displays currently selected XT-4K-VIP-TX Transmitter ID
6
Assignable bi-directional RS-232 port – Connect to third party control device to extend RS-232 commands to any/
multiple X
T-4K-VIP product’s
RS-232 port
7
Reset button - P
ress once briefly to reboot the product or press and hold for 5 seconds to factory reset
8
Firmware Micro-B USB port - Used to update XT-4K-VIP-RX MCU firmware
9
P
ower LED indicator - Flashing status light when the unit is booting. Solid status light when finished booting
q
Link LED indicator -
F
lashing status light when the unit has booted and is ready. Solid status light when receiving
video
w
LAN Connection (PoE) - Connect to any supported Layer 2 / Layer 3 Managed Switch for HDMI video distribution
e
LOOP OUT - Connect to LAN connection on subsequent XT-4K-VIP-RX unit for daisy-chain of video IP stream
r
HDMI output – Connect to a HDMI display
t
MCU firmware update switch - Used to place R
eceiver
product into firmware update mode
y
L/R analog audio line output - Used to breakout analog audio from HDMI signal
NOTE:
Source input must be PCM 2 channel audio for analog audio outputs to work. VIP products do not down-
mix multi-channel audio signals
. Audio outputs are fixed line level output and RX supports u
p to 96Khz audio
formats only
u
Power port – Use 24V 1A DC adaptor (sold separately) if not using a PoE network switch
NOTE:
Configuration of Xantech XT-4K-VIP-RX products can be achieved manually or using the XT-4K-VIP-ACM.
Please see the full product manual (available online at
www.xantech.com
) for further details.
XT-4K-VIP-RX Rear Panel
Panel Description - XT-4K-VIP-RX Receiver
2
3
5
6
10
1
4
8
9
16
7
10023196_RevA9_Quick_Reference_Guide_Xantech_XT_4K-VIP_TXRX_0304_PRINT.indd 3
03/04/2019 09:51