Xantech MRKP2E, Installation Instructions Manual

Page: 6 / 12

10
MRKP2E – REAR CONNECTORS
Figure 2.4: Rear connector board of MRKP2E Keypad
Note: The IR Out feature on this keypad comes disabled from the factory and if
needed, it should be enabled using the Xantech Universal Dragon
programming software.
IR
IN
IR
O
U
T
+
1
2
V
D
C
GN
D
GN
D
TO CONTROLLER
IR SENSOR
ENABLE JUMPER
(JP3)
JP3
XANTECH
IR RECEIVER
TO EXPANSION
KEYPAD
11
Installation
The MRKP2E is designed to mount in a UK and EU standard two gang
electrical back- box (see Specifications sections for details). Typical mounting
height is 56-60 inches (1.53 meters) from the floor to the bottom of the frame.
This provides optimum “eye-level” viewing for the largest number of people.
Route the CAT-5 cable from the MX88 into the back of the electrical back-box,
terminate it with an RJ-45 connector after it is passed through the electrical
back-box. Connect it to the appropriate RJ-45 connector on the rear of the
MRKP2E (“CONTROLLER” for connecting to MX88, or “EXPANSION” if
connecting to an extension keypad). If using an IR Receiver, strip the ends of
three conductors of the IR receiver’s cable and insert into the appropriate
terminals of the IR Input terminal block shown in Figure 3.1.
Once connections are made, mount the MRKP2E into the electrical back-box
using the two provided screws. Mount the Trim Plate Bracket as shown in the
Figure 2.5 on next page, and then snap the Screw-less Trim Plate in place.
Note: Do not mount the MRKP2E in the same electrical back- box as high voltage
devices such as electrical outlets or switches.
Figure 2.5: MRKP2E keypad installation in EU/UK standard
Two-gang back-box
DUAL-G ANG
WALL BOX
MOUNTINGSCREWS(M3.5 x 30MM)
Note: Mounting screws are included with
most electrical back-boxes.
Extra mounting screws are also included
with the MRKP2Eproduct in case
the back-box screws are not supplied or
are somehow not suitable for use.
MRKP2E
TRIM PLATE
TWO-GANG
ELECTRICAL
BACK-BOX
MOUNTING SCREWS (M3.5X30MM)
Note: Mounting screws are included
with most electrical back boxes.
Extra mounting screws are also
included with the MRKP2E product in
case the back box screws are not
supplied or are somehow not suitable
for use.