08905150A
-
6
-
[7] IR BUS
The IR_IN port utilizes a 3.5mm mono jack. Use this port to connect to an IR emitter output port of a
Xantech connecting block.
PLUG
CIRCUIT
TIP IR
SIGNAL
SLEEVE GROUND
[8] CAT5 ZONE OUTPUT
This is an Output connection to the HDRXSG01 receiver module. It utilizes standard CAT5 cable. Be
sure to verify CAT5 wiring connection is correct before installation.
[9] COAXIAL ZONE OUTPUT
These Gold-plated RCA jacks provide for a connection to HD monitors. The jacks have been color-
coordinated to match the HD monitor input color scheme. Note that the CAT5 and coaxial Zone
Outputs can be used at the same time.
IMPORTANT NOTICE
After connecting the CAT5 cable to the receiver (HDRXSG01), the
power supply to the receiver should be unplugged for a few seconds
and then reconnected. This allows the receiver to go through the full
process of line length and line quality self-calibration.
As an alternate process to this procedure, the power may be cycled
off for a few seconds and reapplied to accomplish the same full self-
calibration process.
If for some reason the system loses power at the receiving end
(HDRXSG01), the transmitting end (HD88CC5), or both ends, the full
self-calibration process will automatically occur.
Summary of Contents for HD88C
Page 11: ...08905150A 11 Notes...
