2
284M
BLACK (IR OPAQUE) MOUSE SHIELD.
• An optional shield, available from Xantech as model MS-1, fits over both the 284M mouse emitter shell
and the sensor window of the controlled component. It prevents unwanted external IR signals from
passing through or leaking past it.
• The MS-1 also prevents IR from the 284M from radiating backward into the IR sensors of other
components.
• It is especially useful for zone controlled applications where you want the equipment controlled only by
the 284Ms that are fastened over the component IR sensors.
Satellite Receiver
To 120 V AC
(Unswitched)
781RG
Power Supply
284M
Emitter
284M
Emitter
EQUIPMENT CABINET, CLOSET, ETC.
AV Receiver
VCR
Hand Held
Remote
291-00
IR Receiver
284M
Mouse Emitter
IR Sensor
Window
789-44
Connecting Block
Spare Emitter or use
on additional component
12VDC
+12 VDC
GND
STATUS
IR IN
EMITTERS
789-44
CONNECTING BLOCK
®
IR
RCVR
Side View
Top View
284M
Emitter
Adhesive Layer
MS-1
Mouse Emitter Shield
Controlled Component
MS-1 and 284M installed
over IR sensor. Trim edges
of MS-1 as needed (see text).
Install as follows:
1. Before removing the adhesive covers from the shield or the emitter, fit them together and accurately
position them over the IR sensor window of the component.
2. Neatly trim the shield (if needed) being sure that it overlaps the extremities of the equipment’s IR
sensor window.
3. Remove adhesive covers from the shield and the emitter and stick them onto the IR sensor window.
CONNECTING THE EMITTERS
• Simply insert the mono mini-plug of the 284M emitters into the "EMITTERS" or "OUT" jacks on any of the
Xantech Connecting Blocks or Controllers.
• CAUTION:
DO NOT plug them into the IN/OUT or HIGH OUT jacks on the 791-44 and 790-00
Connecting Blocks. To do so will destroy the
emitters!
• Fig. 5 illustrates a typical basic system using the
284M emitters.
Fig. 4
Using the MS-1 Mouse Emitter Sheild
Fig. 5
