
2
282M
BLACK (IR OPAQUE) MOUSE SHIELD.
• An optional shield, available from Xantech as model MS-1, fits over both the 282M mouse emitter shell
and the sensor window of the controlled component. It prevents unwanted external IR signals from
passing through or leaking past it.
• The MS-1 also prevents IR from the 282M from radiating backward into the IR sensors of other
components.
• It is especially useful for zone controlled applications where you want the equipment controlled only by
the 282M fastened over the component IR sensors.
Install as follows:
1. Before removing the adhesive covers from the shield or the emitter, fit them together and accurately
position them over the IR sensor window of the component.
2. Neatly trim the shield (if needed) being sure that it overlaps the extremities of the equipment’s IR
sensor window.
3. Remove adhesive covers from the shield and the emitter and stick them onto the IR sensor window.
Side View
Top View
282M
Emitter
Adhesive Layer
MS-1
Mouse Emitter Shield
Controlled Component
MS-1 and 282M installed
over IR sensor. Trim edges
of MS-1 as needed (see text).
Satellite Receiver
To 120 V AC
(Unswitched)
781RG
Power Supply
282M
Emitter
282M
Emitter
EQUIPMENT CABINET, CLOSET, ETC.
AV Receiver
VCR
Hand Held
Remote
291-00
IR Receiver
282M
Emitter
IR Sensor
Window
789-44
Connecting Block
12VDC
+12 VDC
GND
STATUS
IR IN
EMITTERS
IR
RCVR
789-44
CONNECTING BLOCK
®
CONNECTING THE EMITTERS
• Simply insert the mono mini plug of the 282M
emitters into the "EMITTERS" or "OUT" jacks on
any of the Xantech Connecting Blocks or Control-
lers.
• CAUTION:
DO NOT plug them into the IN/OUT
or HIGH OUT jacks on the 791-44 and 790-00
Connecting Blocks. To do so will destroy the
emitters!
• Fig. 5 illustrates a typical basic system using the
282M emitters.
Fig. 4
3-13-00
Fig. 5