6 Repacking Procedure __________________________________________________________________
Removing a 2,000 Sheet Feeder
If a 2,000 sheet feeder is attached to your printer, it must be removed before the printer is shipped.
1.
Make sure the feeder’s power cord is disconnected and any media is removed from the feeder’s
drawer.
2.
Disconnect the feeder’ built-in power cord from the printer’s power receptacle (fig. 12).
Fig. 12 Disconnect the Feeder’s Power Cord
3.
Remove the printer from the sheet feeder using the following procedure.
Note:
If a paper cassette feeder is used in addition to the 2,000 sheet feeder, first remove the
printer from the cassette feeder. See “Removing a Paper Cassette Feeder” earlier in this
document. Then, remove the printer from the 2,000 sheet feeder using the following
procedure.
a.
Remove the 2 IOT screws securing the printer to the feeder (fig. 13).
Note:
If a paper cassette feeder is used in addition to the 2,000 sheet feeder, you removing
2 IOT screws securing the cassette feeder to the 2,000 sheet feeder, rather than the
printer to the sheet feeder.
Fig. 13 Remove the Securing Screws
Fig. 14 Lift the Printer off the Feeder
b.
Lift the printer off the feeder vertically until the printer is free of the feeder’s stubs (fig. 14).
The set the printer on a stable surface that will support its weight.
4.
Remove the 4 Allen screws securing the footers on the feeder (fig. 15) and pull the footers out (fig.
16).
