17
©2013 XAircraft All Rights Reserved.
Motor will stop under conditions below:
1)
After motors started, if there is no pushing throttle in 3 seconds, another
down-inside/down-outside operation can stop the motors immediately.
2)
When copter already landed and throttle down to lowest, motors stop immediately.
3)
When copter still in the air and throttle down to lowest, motors will stop in 3 seconds.
Notice:
After motors stopped in the air, you can push throttle to restart the motors in 3 seconds.
The conditions motor cannot be started:
1)
LED shows red or flashes red.
2)
LED shows yellow with the weak interference of magnet in GPS Mode.
3)
Not connect with receiver in a right way or not calibrate RC reverse correctly.
Auto Take-off
Push throttle to neutral point immediately after motors started, SuperX will auto take -off and
hang about on 1.5 meters high. The height hold precision is affected near the ground; some types
of small copter can get rid of the ground effect about 1 meter high.
Height Hold
Notice:
1.
In manual mode, Height Hold function is unavailable.
2.
In other flight modes Height Hold function is always on.
Keep Height when throttle at
neutral point
Lifting when throttle higher
than neutral point
Falling when throttle lower
than neutral point
During a fast cruise flight, copter height variance is normal due to the varying pressure.
