@2019 XAG Australia All Rights Reserved Page | 15
Manual Remote Controller Calibration
There are three pre-programmed mode on the ARC1 Manual
Remote Controller. XAG recommends its user to calibrate their
Remote Controller on a frequent basis to ensure safe operation.
Follow the diagrams and steps listed below to calibrate the remote
controller with an A2 Pilot Phone
1.
Select the ARC1 Icon to Enter the settings Page
2.
Select “Control Stick” to enter the Mode Selection Page
3.
Select “Calibrate Control Stick” to begin Calibration
4.
Follow the steps indicated on the screen, and proceed to the
next step of the calibration process by pressing button A/L or
B/R on the ARC1
5.
Midpoint Acquisition Calibration: This step requires no
maneuvers, but ensures that both control sticks are centre by
nature and no forces are applied to the controls.
Press A/L or B/R on the ARC1 Remote Controller to proceed to
next step
