1.
B
EFORE
S
TARTING
There are two holes under a plastic cover on the left side of terminal (Figure 1). One is a power
jack; the other is an USB programmable port (Figure 2). Rechargeable battery is on the back side of
terminal (Figure 3).
Figure 1 Figure 2
Figure 3
Adapter spec:
DELTA_ADP-36JH B
Input: 100-240Vac, 50/60Hz 1A; Output: 12Vdc, 3A
Car
Charger:
EDAC POWER ELECRONICS CO., LTD. / ED1025
Input: 11-16Vdc, 5A; Output: 12Vdc, 2.5A
Operating Temperature: 0
℃
to 40
℃
Battery pack: CHENG UEI / FD400 7.4V, 2.3Ah
RTC battery spec: 3V, CR2032
Caution: The cover (Figure 3) shall be provided with a means to keep it closed during normal operation.
Caution: Risk of explosion if the battery is replaced by an incorrect type. Please dispose of used battery
according to the instructions.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord be
used.
2.
P
OWER
O
N THE
T
ERMINAL
Install the battery, or plug the power cord into the power jack and plug the power adapter into a
120-volt electrical outlet or into a surge suppressor (recommended) after the power cord is
connected to the power adapter. Press the power button at the front of device (Figure 4) until the
system is booted up.
Figure 4
3.
L
OADING THE
P
APER
Gently pop the printer cover’s latch to open the cover (Figure 5); then lift the cover. Load a roll of
thermal paper (Appleton 1012 recommended) into the printer (Figure 6). Load it so that the
print-side of the paper will feed out facing the operator. Close the cover by pressing down evenly
on both side tabs, or by pressing on the center of the printer cover. Use the serrated bar to tear off
any excess paper.
Figure 5 Figure 6
