X2E XORAYA ML-Z7, User Manual

Page: 32 / 208

U
SER
M
ANUAL
X
ORAYA
Z7 | X
ORAYA
ML-Z7
C
OMMISSIONING
32
The datalogger is equipped with an intelligent energy management system
that lowers power consumption to about 1 mA (at 12 V supply voltage) in
sleep mode.
The device goes into sleep mode via the following actions or under the
following conditions:
▪
Pressing and holding the power button (K) for at least 2 seconds.
Current recording stops automatically.
▪
If no data reach the log interfaces and no connection to the
X
ORAYA
Suite is established for 10 minutes, the datalogger shuts down
automatically. This behavior is configured using the main setting
Automatically Switch Off . (
➔
Main Settings)
Users can wake up the datalogger from sleep mode as follows:
▪
Pressing the power button (K)
▪
Switching the power supply off and on
▪
Signal change from 0 V to +12 V at the trigger or wake input (L)
▪
Pressing the trigger/wake button (J)
▪
Activity on a wakeable log interface
4.6 Connecting the datalogger to the PC
This section describes how to connect the datalogger to the PC. To do so,
you will need a standard network cable.
Proceed as follows to connect:

Connect the network cable to a switch.
or

Connect the network cable directly to your PC.

Connect the network cable to one of the LAN host ports (E) on the
datalogger. (
➔
Connections and controls)

The datalogger is fully connected.