9
8
C
ONNECTING
U
P
H
OOKING
UP
THE
VGA S
ENDER
1. Connect the jack on the audio cable (supplied) to the audio out
jack on your PC sound card.
2. Connect the red RCA plug to the socket labelled AUDIO RIGHT
and the white RCA plug to the jack labeled AUDIO LEFT on the
VGA Video Sender.
3. Connect the VGA cables as show below so that the VGA out from
your PC connects to the VGA input on the VT36A and then also
passes to the VGA input on your monitor.
4. Connect the serial port connector to your PC's serial port.
5. Set the channel switch (on the TOP of the unit) to channel A (to the
RIGHT).
6. Plug the VGA Video Sender's Power Supply (the smaller of the
two power supplies) into a convenient 120 volt wall outlet and
plug its jack into the VGA Video Sender.
7. Position the VGA Video Sender in a convenient location and
orient the antenna so that the flat side points in the direction of the
room where you will be installing the Video Receiver.
P
Before you start installing your Big Picture System it is recommended
that you read this entire owner's manual. This will familiarize you
with the basic hardware installation. Then install the hardware. You
will then be able to see a picture from your PC on our TV screen. You
can then visit www.x10.com/software and download the "Boom"
program there, which will give you control over what is sent from
your PC to your TV.
B
EFORE
Y
OU
S
TART
Serial port connecter
