19
18
C
HANGING
THE
X10 H
OUSE
C
ODE
:
The SuperRemote defaults to House
Code A, and in most cases you will not
need to change this unless you are
experiencing interference from a
neighboring X10 system.
1.
Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2.
Use the number
buttons to enter the
number equivalent
to the chosen
House Code
(1=A, 2=B ..16=P).
3.
Press ENTER or OK
to confirm the
House Code. The
LED turns off.
Note:
The House Code you choose must
match the House Code on the
Transceiver and Modules you are using it
with.
1.
Press and hold
SETUP until the LED
indicator lights
steadily. Release
Setup button.
2.
Press and release
any mode button
(except TV), e.g.
AUX.
3.
Press 000.
You can also set any mode key (except
TV) to become an “X10” key. You could
for example make AUX an X10 key.
Pressing this key then puts you in X10
mode and lets you control all 16 X10
Modules on the same Housecode as the
remote, as follows.
Once in X10 mode you can control any
X10 Module by pressing the number
button corresponding to its Unit Code,
followed by the appropriate function key
as follows:
X10 FUNCTIONS:
On:
C
Off:
CHANNEL –
Bright:
Dim:
VOLUME –
All Lights On:
POWER
All Modules Off:
MUTE
Notes:
You cannot dim or brighten an
Appliance Module. If the module was off
and you press Bright or Dim (
or VOLUME -) this will simply turn the
module on.
The above procedure sets the remote to
transmit RF codes to any X10 Transceiver.
If you want it to transmit X10 IR codes to
an IR543 Console press 001 above
instead of 000.
